PCIIO DOS setup instruction: 2005/01/11

This is a DOS command line program that sets PCI IO card's uart/parallel
address to available COM/LPT ports.

To start the setup automatically, add SETIO.EXE to autoexec.bat file and
copy SETIO.EXE to c:\. Simply delete the "SETIO.EXE" line in the
autoexec.bat file if you later decide not to run it automatically.

To run the program manually, after bootup, type SETIO at the command prompt
and hit enter key.

Usage: setio [/option]

Options:
   none :no parameters, set up system COM/LPT ports
         Set PCIIO card's uart/parallel ports to available COM/LPT slots.

  /u x  :set uart starting address, x=io address in hex.
         Assign uarts' starting address before setup the COM ports.
         eg. c:\>setio /u c400

  /c    :show card's config. info.
         Display card's PCI bus information, IRQ, its port address and
         mapping to system COM/LPT.

  /s    :show seg40 system resources.
         Show system COM/LPT ports' address.

  /h, /?:display help message.

